I have been dying to use the color Lichen by Fusion Mineral Paint and it did not disappoint! It's such a soothing green color. Aren’t the spindles amazing on this table? See the makeover below!
The Prep Process:
Once everything was dry I scuff-sanded the piece with 220 grit sandpaper.
After I sanded it, I vacuumed it really well and cleaned it again with Krud-Kutter.
The Painting Process:
For the body of the piece I used Lichen by Fusion Mineral Paint. I applied two coats with my Zibra 2” Palm Pro on the flat areas and my Zibra Round Brush on the spindles letting each coat dry well in-between.
Once both coats were dry, I lightly hand-sanded the edges with 220 girt sandpaper to give the edges a distressed look.
I sealed the entire piece with General Finishes High Performance Top Coat in Flat
I added a new handle from D.Lawless Hardware to highlight the drawer.
As always, thank you so much for tuning in this week for #MondayMakeoversWithFallon. If you want to save this blog post so you can refer back to it, make sure you pin it to your Pinterest page and/or feel free to share it elsewhere. I look forward being with you next Monday and don’t forget to tune in tomorrow for my educating video tutorial/tip for #TuesdayTipsWithFallon!!
*Please note, this post does contain affiliate links.